BC-140 fast ADC problem

J\vrgen Tegenfeldt (Jorgen.Tegenfeldt@Kemi.UU.SE)
Mon, 27 Sep 1993 13:05:39 +0200

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Gerald Pearson: "acquiring >>64K transients on a FID with an AMX"
Previous message: C.S.RAMAN: "Felix"
Next in thread: charlie thibault: "Re: BC-140 fast ADC problem"

I have an MSL system with a Bruker BC-140 fast ADC (2x20MHz according to
Bruker). For certain experiments I would like to sample a signal as fast as
possible. Now, DISNMR on the ASPECT does not agree to set SW to more than 5
MHz although I have told the system during installation that I have this
particular ADC, so apparently there must be a SW-limit set inside DISNMR
that is lower than that allowed by the ADC. Has anybody else run into this
problem, and, above all, does anybody know about a way to bypass the problem?

Jorgen Tegenfeldt
Department of Chemistry
Uppsala University
Uppsala, Sweden
TEGEN@KEMI.UU.SE

Next message: Gerald Pearson: "acquiring >>64K transients on a FID with an AMX"
Previous message: C.S.RAMAN: "Felix"
Next in thread: charlie thibault: "Re: BC-140 fast ADC problem"