We have been experiencing over the past two years a constant failure of
parts on our AMX-600 (temperature controller, H0 field current, BB power
amplifier power supply, gradient amp power diodes...). I have been trying
to track down voltage instabilities, but I could not detect anything after
monitoring the line for about a week.
Nonetheless I suspect a voltage stabilizer would make no harm, before
calling an exorcist.
Does anybody have experience, suggestions as to the best setup and where to
buy a voltage stabilizer suitable for an NMR spectrometer?
I would appreciate any help in this direction and I will post a summary of
the replies. Also if anybody has alternative explanations for this series
of "accidents"....
Thanks in advance
Stefano
====================================================
Stefano Caldarelli
Section de Chimie de l'Universite'
BCH-Dorigny Tel: ++41 21 692 3802
CH-1015 Lausanne Fax: ++41 21 692 3855
====================================================