Hello,
I have seen someone of the MPI institution, which has done a measurement
of molted polymers
via MAS. He has cooled down the rotor with polymer in liquid nitrogen
and then pushed the
polymer out with a needle like a cork of a wine bottle.
I'll hope this treatment helps you a bit.
Yours
Ulrich Haunz
> I've been having difficulty removing residual amounts of polymer from my
> 2.5 mm solid state rotors. Does anyone know if these can be exposed to
> high temperatures to burn off whatever is left inside? What is the
> temperature limit for the material that makes up the rotor?
>
> Thanks
> Vernon Russell
> __________________________________________________________________________
>
> To subscribe/unsubscribe: Please send a note to
>
> bruker-users-request (at) purcell(dot)cchem(dot)berkeley(dot)edu
>
> For subscriptions, please include a list of Bruker instruments you are
> using, see http://www.cchem.berkeley.edu/nmr/BUM.txt
> E-mail archives are at http://calmarc3.cchem.berkeley.edu/archives/bum.html
> ___________________________________________________________________________
>
>
This archive was generated by hypermail 2b29 : Wed Dec 26 2007 - 09:47:04 PST