Re: Crashing APSECT3000?

From: Jane Strouse (strousej@chem.ucla.edu)
Date: Thu May 18 2000 - 13:48:09 PDT


    Another bit of voodoo I would add to Clemens' suggestions is to use an
eraser on the board edge connectors while you have the boards out. I have
seen this completely cure computer problems.

Jane

>>Sender: cga@NMR.BRUKER.COM
>>From: Clemens Anklin <Clemens.Anklin@NMR.BRUKER.COM>
>>Organization: Bruker Instruments Inc
>>X-Accept-Language: en
>>To: Paul Shin <alchemy@tiger.cc.oxy.edu>
>>CC: bruker-users-mail@bloch.cchem.berkeley.edu
>>Subject: Re: Crashing APSECT3000?
>>References: <v04220802b549cf4d174f@[134.69.13.113]>
>>Date: Thu, 18 May 2000 16:22:55 -0400
>>Content-Length: 1585
>>
>>Dear Paul,
>>
>>there is definitely the age of these computers that could cause a problem.
>>The other "easy to fix" causes could be:
>>
>>- Dust, did you regularly clean the dustfilter behind the frontpanel of the
>>Aspect 3000?
>> or have massive amounts of dust accumulated around all the components.
>> Make sure the airflow through the computer is unobstructed.
>>
>>- Bad contacts, one of the "magical" procedures with Aspect 3000 boards
is to
>>pull them out of the computer and lay them flat on a surface with the
chips
>>on top. It is advisable, if available to
>> put an antistatic or conducting material underneath it. The you push
down all
>>the socketed IC's
>> down. Put your two thumbs on the chip and press firmly. If it is all the
way
>>down nothing should
>> happen, if it is not you will hear a slight noise when it goes in. Then
make
>>sure all dust caught
>> between the legs of all components is removed.
>>
>>- Power supply problems, your power supply could intermittently drop out.
>>
>>I hope it's one of the above, that can easily be fixed.
>>
>>Regards
>>
>>Clemens Anklin
>>
>>
>>> Does anyone have any ideas of what could be causing an APECT 3000
>>> computer (for an AC200 system) to crash intermittently? Aside from
>>> the obvious age issue, are there other potential causes that may be
>>> fixable?
>>>
>>
>>--
>>Clemens Anklin, Ph.D. Director of NMR Applications
>>Bruker Instruments Inc. Phone:(978)667-9580 ext.144
>>19 Fortune Drive Fax:(978)667-2955
>>Billerica MA 01821 e-mail: clemens.anklin@nmr.bruker.com
>>----- or try "cga1956" on AOL/Netscape Instant Messaging -------
>>
Dr. Jane Strouse
Dept. of Chemistry and Biochemistry
UCLA
Los Angeles, CA 90095-1569
(310)-825-9841 - voice
(310)-825-0393 - FAX
strousej@chem.ucla.edu



This archive was generated by hypermail 2b29 : Sun Dec 31 2000 - 01:15:02 PST