setting bsms drift

From: Phil Dennison (dennison@uci.edu)
Date: Mon May 12 2003 - 18:39:45 PDT

Next message: art ragauskas: "Postdoctoral Position - Georgia Institute of Technology"
Previous message: Kees van de Kolk: "Re: Loss of x-nucleus signal after wobb?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi all,

I'm having some trouble setting the field drift value through the
bsms keypad. As I understand it I should set the required value, then
use the security code to save that setting.

The problem is that I can't set the drift to a non-zero value, the
keypad just beeps when I turn the nod.

I'm sure there's something simple I'm missing....

Regards,

Phil.

-- 
Dr Phil Dennison
NMR Facility Director			(949)824-6010 (office)
Department of Chemistry			(949)824-5649 (lab)
University of California, Irvine	(949)824-8571 (fax)                 
Irvine, CA 92697-2025			dennison@uci.edu       
USA

Next message: art ragauskas: "Postdoctoral Position - Georgia Institute of Technology"
Previous message: Kees van de Kolk: "Re: Loss of x-nucleus signal after wobb?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Dec 30 2003 - 01:04:22 PST