Phasing Cursor Parameter

banvilledl (X30006MG@usrd0.zen.com)
Thu, 04 May 95 13:18:00 PDT

I have an AMX500 and was trying to re-process some old 2D data using my
"proc" printout. This gives both the PHCO and PHC1 values but does NOT give
the location of the cursor (a.k.a. the pivot point) important for the first
order phase correction. Does UXNMR keep track of this value? It must if you
can take an old proc file a re-process correctly. Does anyone know where
this value is located?

Thanks in advance
debbie
banvilledl@zen.com